205-7
Tranzview Smatlab ISA Bus 16 Photo Isolator Input/ 16 Relay Output Card
Board for remote digital I/O over your ethernet
Solution for Your Developing DAQ Application System


















Tranzview Systems Hardware Based
PC Systems
Video Capture card


PC COM RS232 Serial Card
+ Decision Industrial I/O Card
+ Decision Analog I/O Card
+ Decision Data Acquisition I/O Card










SMARTLAB 16 RELAY/ 16 PHOTO ISOLATOR CARD




The 16 channels relay output / photo isolator input adapter provides relay output functions. The relay output part provides 16 relays to drive 16 different output channels. Each relay channel can be used to control ON/ OFF of external devices, to drive external high power relays, to activate alarms¡K etc.

The photo isolator input part provides 16 photo couple digital input channels, which allow the input signals to be completely floated and prevent the ground loop.

The features of 16 channels relay output / 16 channels photo isolator input adapter are:

#Support 16 relay output channels and 16 photo couple input channels

#Max contact rating for relay: 150V / DC 1AMP.

#Response time for relay: 1 ms minimum.

#Contact resistance for relay: 0.2-OHM maximum.

#Support several operating modes which are Programmable

#Sixteen LED indicate when I/O is operating.

#Port address selectable.

Hardware Installation:

Before you use the 16 channels relay output / 16 channels photo couple input adapter, you must ensure that the I/O address is set correctly, and set IRQ that you needs. Observe the figure in the follows, the proper settings for the 16 channel s relay output / 16 channels photo couple input adapter is described in the following.

Technical data - Isolated input Output and Relay Output
Isolated input: The digital signal input with isolated protection.
Photo Isolator :
Word File 4N35
Hyper Link

BRD-1A05D