205-1
Tranzview Smatlab ISA Industrial Control Card
Interface card for remote digital I/O over your ethernet
Solution for Your Developing DAQ Application System



















Tranzview Systems Hardware Based
PC Systems
Video Capture card


PC COM RS232 Serial Card
+ Decision Industrial I/O Card
+ Decision Analog I/O Card
+ Decision Data Acquisition I/O Card









PCI INDUSTRIAL CONTROL CARD



The PCI bus 4 channel industry control board is a 32 bits PCI bus board with Plug and Play (PnP) features, it is a programmable I/O interface card for PC/486, Pentium, or compatibles. The PnP features let hardware configuration for IRQ and I/O address is detected by BIOS automatically, you don¡¦t need set switch and jumper.

The PCI bus 4 channel industry control board provides total 4 digital I/O ports, each I/O port contains 16 I/O lines, and can be set either input or output by the user's program. The signal assignments of PCI bus 4 channel industry control board is designed as a standard configurations, so that it can be used to connect to the expansion board for several applications, the expansion card family are 16/8 channel relay output board, 16/8 channel isolator input board, 8 channel SSR/Logic output board ... etc.

The features of the PCI bus industry control board are:

#32 bits PCI bus with Plug and Play (PnP) features.
#Provides four I/O ports.
#Each I/O port contains 16 digital I/O lines, total 64 I/O lines.
#Standard signal assignment to connect to expansion board family.
#Provides DII device driver for PnP features.

Hardware Installation:

Your PCI bus 4-channel industry control card is design to be inserted in any available PCI slot in your PC/AT, PC/386, PC/486, Pentium or compatibles. In order to gain access to the expansion slots, follow the steps listed below:

1.Turn off all power to your computer and all peripheral devices before installing your industry card.
2.Remove the cover of the computer.
3.Insert the industry control card into any available PCI slot. Make sure the adapter is firmly seated in the chosen slot.
4.Replace the cover of the computer.
5.Connects the expansion cable to 25 pin connectors.
6.Turn on the power of your computer; the PnP features will recognize the industry control card.